Show All /
Details about DIY 3D Printer Control Board Compatible For Ultimaker PCB RAMPS Dual Print
£19.99
Description
DIY 3D Printer Control Board Compatible For Ultimaker PCB RAMPS Dual Print
UK STOCK, UK SELLER
Specification
3D Printer Control Board DIY Compatible for Ultimaker PCB RAMPS Dual Print DT
Features:
- 4CH JST connector
- Could control 5 stepper motors(3 is X,Y and Z-axis extrudder)
- Set stepper length by jumper
- 3 times 55A MOSFET output(w/LED indicator lamp)
- All Pin extension from 15V to 19V
- Thermocouple input. 100K thermocouple suggested
- Normally open fan-cooling devices included 12V regulator
- LCD backlit adjustment controlled by software
- Support dual extruder printing.
- 4CH JST connector
- Could control 5 stepper motors(3 is X,Y and Z-axis extrudder)
- Set stepper length by jumper
- 3 times 55A MOSFET output(w/LED indicator lamp)
- All Pin extension from 15V to 19V
- Thermocouple input. 100K thermocouple suggested
- Normally open fan-cooling devices included 12V regulator
- LCD backlit adjustment controlled by software
- Support dual extruder printing.
Important Note Before you decide to Buy: This item is provided with NO instructions or data sheets. We are unable to provide any technical support, it is therefore essential that you have the resources available to make use of this item and how it operates within the electrical specifications. We check and test each item, we are therefore unable to accept any returns based on a faulty module.
This item will be fully tested prior to despatch. Buy with confidence.
