Welcome visitor, please login or create an account.

1.5A Mini Dual Channel DC Motor Driver replacement for L298N PWM Speed Control

Manufacturer: Generic
Product Code: L298N-2
Availability: In Stock
FastFind: 238533


1.5A Mini Dual Channel DC Motor Driver PWM Speed Control





  • This motor drive module is ideal for use in battery-powered smart car, toy cars, robots. Supply voltage 2V ~ 10V, can drive two DC motors or a 4-wire 2-phase stepper motors ,you control forward rotation or reverse rotation, also the rotation speed can be controller. Can provide a continuous current of 1.5A, peak current up to 2.5A, thermal shutdown protection and will be automatically restored.

    Product Highlights:

    Built-in low on-resistance MOS switch, minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered.
    More efficient then the L298N.
    Small size, light weight, ultra low standby current, is the ideal choice for your motor control model.

    Product parameters:

    Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor.
    The module supply voltage 2V-10V.
    Signal input voltage 1.8-7V. (do not exceed 7v)
    Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA).
    Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction.
    Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall.
    Product Size: 24.7 * 21 * 5mm (length, width, height), ultra-small size.
    The mounting hole diameter: 2 mm.


    1. If the power supply is reversed this will cause permanent damage to the module.
    2. If the output is shorted to ground or the output is short circuited, or the motor stalls, the chip will over heat, if the supply voltage is near 10v or over, causing the peak current to exceed 2.5A this will cause permanent damage to the module.
    3. We will fully test the unit prior to sending your order.

Package includes:

  1.5A Mini Dual Channel DC Motor Driver Module Beyond L298N PWM Speed Control

Important note:
There are no identication markings on the chip.

Important Note Before you decide to Buy: This item is provided with NO instructions or data sheets. We are unable to provide any technical support, it is therefore essential that you have the resources available to make use of this item and how it operates within the electrical specifications. We check and test each item, we are therefore unable to accept any returns based on a faulty module.

This item will be fully tested prior to despatch. Buy with confidence.

Powered by Flexibasket